Clear-Com HME DX200 - Manual (Page 5)

5
OPERATION
Headset Connection
If you are using a headset with the WS200, plug it into the headset connector. When using a headset, if the red light
over the SPEAKER button is on, incoming communication can be heard through the headset and the speaker. If the
red light over the SPEAKER button is off, incoming communication can only be heard through the headset.
Push-To-Talk (PTT) or Hands-Free (HF) Mode Setting
• Be sure the WS200 power is off.
• To set up the WS200 for operation in the PTT mode, press and hold the VOLUME down ▼ and ISO buttons
while you press and release the POWER button to turn the unit on. Then release the VOLUME down ▼ and
ISO buttons.
• To set up the WS200 for operation in the HF mode, press and hold the VOLUME up ▲ and ISO buttons while
you press and release the POWER button to turn the unit on. Then release the VOLUME up ▲ and ISO buttons.
NOTE:
Mode settings are saved in memory, and only need to be reset if you want to change between PTT and HF
operation. Mode settings affect both ISO and IC communication.
Headset
connector