Clear-Com HME DX200 - Manual

HM ELECTRONICS, INC.
14110 Stowe Drive, Poway, CA 92064 USA • Phone: 1-800-848-4468 Fax: (858) 552-0172
HME# 400G612
Rev B 7/3/08
WS200
Wireless Speaker Station
OPERATING INSTRUCTIONS
The WS200 Speaker Station can be used with a DX100 or DX200 system, together with Beltpacs and WH200
All-in-one Headsets. It provides wireless communication through its built-in microphone and speaker or a plug-in
headset. A remote speaker can also be connected to the unit. The Speaker Station can be used on a table top or
mounted on the wall. It can be operated with standard AC power, 12-14VDC or with six AA batteries or an optional
rechargeable battery. A power supply with cord and a battery sled are provided.
SETUP
Wall Mounting
If you choose to mount the WS200 on the wall and if AC operation is required, it must be mounted close enough to an
electrical outlet to be reached with the power supply and cord.
• Hold the unit against the wall where you will mount it and
mark the wall through the four holes in the flanges on its left
and right sides.
• Drill holes in the wall at the four marked spots, and mount
the WS200 over the holes with your
selected hardware (not provided).
1 2
3 4