Clear-Com HME DX200 - Manual (Page 6)

6
Routine Operation
Power On/Off
• To turn WS200 power on, press and release the POWER button.
— Red lights will go on over the POWER, ISO and IC buttons.
— If listening with a headset, or the speaker is turned on, you will hear “Power on, Speaker #, Version #.”
— The light over the ISO button will go off.
— The light over the IC button will change to green.
• To turn WS200 power off, press and hold the POWER button for 2 seconds.
ISO / IC Buttons
The ISO button is used to communicate with Beltpac and All-in-one Headset users registered to your base
station, and in the case of the BS200 Base Station, with the base station operator. Pressing the ISO button on
the WS200 will also send audio to any wired product connected to AUX OUT on the BS200 Base Station if the
ISO+ button on the base station is on. The ISO feature can be locked out, causing the ISO button to function
the same as the IC button.
The IC button is used to communicate with Beltpac and All-in-one Headset users registered to your base
station, and in the case of the BS200 Base Station, with the base station operator. Pressing the IC button on the
WS200 will also send audio to the 2-wire and/or 4-wire connector on the rear panel of the BS200 Base Station.
Push-To-Talk Mode
• Press and hold the ISO or IC button while speaking.
— The green light over the button will be flashing when the unit is transmitting.
• Release button to listen on headset speaker or internal speaker, if “ON.”
— The green light over the button will be on steady.
• Adjust volume level with VOLUME up ▲ and down ▼ buttons if necessary.
Hands-Free Mode
You must be using a headset plugged into the WS200, and the speaker must be off for hands-free operation.
• Quickly press and release the ISO or IC button.
— The green light over the button will be flashing.
• Speak and listen as in a normal telephone conversation.
• Adjust volume level with the VOLUME up ▲ and down ▼ buttons if necessary.
• Press and release the ISO or IC button again to end communication.
— The green light over the IC button will be on steady.
• Press and release the ISO or IC button if you want to speak again.
— The green light over the button will begin flashing again.
• Pressing and holding the ISO or IC button for more than a half second will result in PTT operation.
ISO Lockout Mode
To set the WS200 with the ISO feature locked out, with the power off, press and hold the IC button while you
press and release the POWER button. You will hear “Power on, Speaker #, Version #, ISO off.” When set up
for the ISO Lockout mode, the ISO button will operate the same as the IC button, in either hands-free or PTT
communication.
To reset the ISO feature for normal ISO button communication, with the power off, press and hold the ISO and IC
buttons while you press and release the POWER button. You will hear “Power on, Speaker #, Version #, ISO on.”
CALL Light Function
If the CL200 (optional) Call Light button is pressed, or a call tone from an RTS or ClearCom intercom system
is received through the CL200 on the 2-wire circuit:
• One short beep will sound in the WS200 speaker or headset, and will also be heard through all Beltpacs or All-
in-one Headsets registered to the same base station as the WS200.
• The yellow CALL light next to the POWER button on the WS200 will flash 3 times and pause, then flash
3 times and pause, then flash 3 final times.