Clear-Com HME DX200 - Manual (Page 4)

4
MB100 Base Station
CLR REG
button
REGISTRATION
STATUS
display
RESET
button
If registration failed:
• A voice message will say “Power on, Speaker, Version #, Begin registration, …”
The ISO and IC lights on the WS200 will be blinking red, and there may be a delay of up to
90 seconds before you hear “Registration failed.”
• Press the RESET button on the base station. When the REGISTRATION STATUS display becomes
blank, press the REG / REGISTER BELTPAC button on the base station and register the WS200 again.
If registration fails again, call your dealer for assistance.
If you try to register more than 15 Beltpacs, All-in-one Headsets or Speaker Stations:
• An F will appear on the REGISTRATION STATUS display on the base station and you will hear
“Registration failed.”
• Clear all current registrations as follows:
— If you have a MB100 Base Station,
press the CLR REG button and the RESET button
at the same time. Continue holding the CLR REG
button after you release the RESET button, until
the clear code “c” (lower case) appears on the
REGISTRATION STATUS display.
— If you have a BS200 Base Station,
press the RESET REGISTRATION button
and the RESET button at the same time. (To press
the RESET button, insert a small paper clip or similar
object into the RESET hole below the RESET
REGISTRATION button.) Continue holding the
RESET REGISTRATION button after you release the
RESET button, until the clear code “c” (lower case)
appears on the REGISTRATION STATUS display.
• Register all active Beltpacs, All-in-one Headsets and Speaker Stations, one at a time.
All previously registered units must be re-registered.
BS200 Base Station
REGISTRATION
STATUS
display
RESET
REGISTRATION
button
RESET
button
(recessed)
MB100 Base Station BS200 Base Station
REGISTRATION
STATUS
display
REGISTRATION
STATUS
display