Clear-Com FreeSpeak Beltpack - Manual (Page 56)

Clear-Com Communication Systems
Eclipse Wireless Communication System
3 - 2
Antennas with different coverage patterns (directional units) that are
appropriate for the 1.9 GHz range may be substituted for the provided
antennas, if variations in coverage pattern are required.
TRANSCEIVER ANTENNA BOTTOM/CONTROL
PANEL
Figure 3-2: Eclipse Transceiver/Antenna Bottom/Control Panel
Serial Data Connector
This 3 mm (1/8 inch) tip-ring-sleeve (TRS) connector is used for
upgrading the firmware in the transceiver/antenna. It will typically be
unused.
Data Signal LED
This yellow LED indicates that a connection has been established
between the Eclipse base and the transceiver/antenna, and that it is
actively creating a coverage zone within which the beltpacks can
operate. If it is off, check the cable connections at both ends, as well as
the powering.
Matrix Connector
This RJ-45 connector is used to connect the bi-directional signal from
the Eclipse base, directly or via the splitter. Up to 1,000 meters of
4-pair 24 AWG CAT-5 cable can be used for this connection between
base and transceiver/antenna. If 26 AWG CAT5 cable is used the
maximum distance is 500 meters.
1
2
3