Clear-Com FreeSpeak Beltpack - Manual (Page 36)

Clear-Com Communication Systems
Eclipse Wireless Communication System
2 - 2
is used to select the key and appears whenever a key selection is
required. The page which appears is the one which was current when
programming mode was entered.
If, having entered programming mode, you find that the required key is
not on the page which is displayed, go to the page selection menu.
This indicates (and puts the cursor on to) the page number which was
selected. It also offers the facility to change the current page number if
necessary.
To see both the page number and its content simultaneously, go to
normal operation as described in the operational information.
MASTER VOLUME CONTROL
The master volume control is set from the main page. The scroll
buttons will change the current page if pressed momentarily but if
pressed and held will change the volume setting.
Press and hold one of the scroll buttons until volume bars change then
use the scroll buttons to adjust the master volume as indicated by the
volume bars until the required level is reached.
BELTPACK PROGRAMMING - MENU MAP
On the menu map below, the flow is downwards and to the right unless
indicated otherwise.
MAIN PROGRAMMING MENU
This is the main menu for programming the Beltpack.
You reached this menu by holding both the UP and DOWN keys
pressed for at least 3 seconds. To return to normal operation, select
Exit (the Up arrow on the display) and press pushbutton C.
To navigate around any menu, use the UP and DOWN scroll buttons to
highlight the required item (the highlighted item is shown in inverse
video). Then press Pushbutton C (effectively the “Reply/Answerback”
key in normal mode or "Enter" key when in Program Mode) to
implement the selection.