Clear-Com FreeSpeak Beltpack - Manual (Page 30)

Clear-Com Communication Systems
Eclipse Wireless Communication System
1 - 1 2
Note: Two-wire and four-wire devices can have dual
talk-and-listen or just listen assignments.
SETTING AND ADJUSTING LISTEN LEVELS
You can adjust a beltpack’s incoming audio volume (“listen level”) in
two ways:
• You can set the overall maximum level for the beltpack by using
the beltpack menu options.
• You can adjust the incoming audio level as you talk or listen on the
beltpack using the beltpack’s talk buttons.
To adjust the overall maximum “listen level” for a beltpack:
1. From the beltpack’s display, scroll to Audio Options, then Headset
Options, then Master Level.
2. Select Master Level by pressing the enter button.
A bar graph appears on the display.
3. Using the right and left scroll keys, adjust the level up or down as
desired on the bar graph.
Typically, the level control will be set to around 2/3 of maximum.
4. When the desired level is reached, press the enter button.
That selection is saved in the beltpack’s memory. The display
returns to the previous screen.
To adjust the listen level as you talk or listen from the beltpack:
• As you talk and listen, rotate an assignment’s talk button to
increase or decrease the incoming volume level (“listen level”) for
that assignment.
• As you scroll between pages, the listen levels for the various
assignments remain intact. For example, rotating the talk button
to increase or decrease the listen level for the first assignment on
page 2 will not affect the listen level set with the same talk button
on page 1 or 3.
• The three lights next to each talk button, labeled “Vol A” and Vol
B,” show you the current listen level. At the lowest audio level, the
green light illuminates. As the listen level increases to moderate,
the yellow light illuminates, and as it increases to maximum, the
red light illuminates. Note that the position of the talk button does
not affect the level that is heard or indicated by the lights.
HEADSET LIMITER
The overall headset volume may also be affected by the headset
limiter value set on the beltpack. See section “BELTPACK MENU
OPTIONS” for more details.