Clear-Com AES-6 - Manual (Page 15)

Vitec Group Communications
AES-6 Digital Interface Instruction Manual 2 - 1
INSTALLATION
INTRODUCTION
This chapter describes the installation of the AES-6 digital interface,
including setting DIP switches and wiring to external devices.
INSTALLATION IN INTERFACE FRAME
To install the AES-6 digital interface module in the IMF-3 or IMF-102
interface frame or Eclipse Median:
1. Select a slot in which to install the interface.
2. Remove the blank plate covering the slot.
3. Slide the AES-6 front card in the front slot and ensure that the card
is fully seated.
4. Select the required AES-6 rear card and slide it into the rear slot
corresponding to the AES-6 front card and ensure that the card is
fully seated.
5. Tighten the AES-6 front panel mounting screws.
6. Tighten the AES-6 rear panel mounting screws.
Note: When hot-plugging any other card in the IMF-3 interface
frame all AES-6 cards in the interface frame should be reset
to ensure correct operation.
CONNECTING THE REAR CARDS
The rear card connections will depend on the type of rear card fitted
and the type of panel or audio link required.
AES-6-CX INTERFACE CARD
The BNC interface rear card provides six RJ-45 ports for connection to
an Eclipse matrix and six BNC ports for connection to 4000 Series II
panels fitted with the PDE4536B interface option, V-Series main
panels fitted with the AES-3 interface option or third party equipment.
These cards may be configured for monaural or stereo use. The 4000
Series II panel types supported by this card are:
• 4224E
• 4215E
• 4226E
• 4294E
• 4212E
2