Clear-Com AES-6 - Manual (Page 11)

Vitec Group Communications
AES-6 Digital Interface Instruction Manual 1 - 5
Table 1-2: AES-6 Hardware Fault Codes
PANEL CONNECTIVITY
The amber port status LEDs on the front panel display the connection
status of each port on the rear card. If a panel connection is detected
on a port the status LED for that port lights continuously.
In mono mode each LED shows the status of the port as described in
Table 1-3. In stereo mode the LEDs operate in pairs reflecting the
pairing of the ports. The first LED in each pair (LED 1,3 and 5)
provides the connection status for the primary channel as described for
mono mode (Table 1-3) while the second LED in the pair will flash at
1Hz with a mark:space ratio of 25:75 indicating that the port is in stereo
mode. This will occur as a result of the DIP switch setting rather than a
connection and the LED will flash even if nothing is connected to the
primary port.
CPU LED CODE LED 1 LED 2 LED 3 LED 4 LED 5 LED 6 MEANING
Flash 1 Flash Off Off Off Off Off RAM test fail
Flash 2 Off Flash Off Off Off Off Corrupt Code Image
Flash 3 Flash Flash Off Off Off Off
FPGA Flash Erase
Fail
Flash 4 Off Off Flash Off Off Off FPGA Load Fail
Flash 5 Flash Off Flash Off Off Off FPGA Test Fail
Flash 6 Off Flash Flash Off Off Off UART Check Fail
Flash 7 Flash Flash Flash Off Off Off
UART Local Loop
Fail
Flash 8 Off Off Off Flash Off Off Not Used
Flash : Flash Flash Off Flash Off Off Not Used
Flash 63 Flash Flash Flash Flash Flash Flash
FPGA Image
missing, waiting for
download