Activating/deactivating the hold function, Adjusting the current outputs, English – Burkert Type 8076 User Manual
Page 38

38
Adjustment and commissioning
Type 8026- 8036- 8076
8.8.6. Activating/deactivating the hold function
• The Hold mode is automatically deactivated when the device restarts after a power interruption, if the Hold mode was activated at
the moment of the power cut-off.
• The Hold mode has no effect on the transistor outputs when they are operating in “Pulse” mode.
System
Calib
Hold
Hold: Disable
Hold: Enable
8.8.7. Adjusting the current outputs
Warning
risk of injury due to wrong adjustment.
• Make sure the Hold mode is disabled (see chap. „8.8.6“).
Outputs
Calib
AC1 / AC2
4mA:
INPUT
20mA:
INPUT
The entered values are not memorised in this menu. Only the values emitted on the current outputs are adjusted after pressing “OK”
when the message “Recalibrate AC outputs?” is shown.
English