Burkert Type 8076 - Manual (Page 27)

27
Adjustment and commissioning
Type 8026- 8036- 8076
8. ADjusTmenT AnD
commissioninG
8.1. safety instructions
Warning
risk of injury due to non-conforming adjustment.
Non-conforming operating could lead to injuries and damage the
device and its surroundings.
• The operators in charge of adjustment must have read and
understood the contents of this manual.
• In particular, observe the safety recommendations and intended
use.
• The device/installation must only be adjusted by suitably trained
staff.
Warning
danger due to nonconforming commissioning.
Nonconforming commissioning could lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
• In particular, observe the safety recommendations and intended
use.
• The device / the installation must only be commissioned by
suitably trained staff.
protect this device against electromagnetic interfe-
rence, ultraviolet rays and, when installed outdoors, the
effects of the climatic conditions.
8.2. When switching on the device
If the message “ERROR - This display does not support this
Element - Contact Bürkert” is displayed, the version of the
display module is not compatible with the software version
of the device. Contact your Bürkert reseller.
When the device is switched on or the display module mounted on
the electronic module, the display indicates the software version of
the display. The display then shows the first screen of the Process
level.
8.3. operating levels
The device has 2 operating levels:
process level
This level is used:
• to read the value of the measured flow rate and/or the sensor
input frequency
• to read the values of both volume totalizers
• to reset totalizer 2
• to read both the lowest and highest values of the flow rate or the
input frequency that have been measured by the device since the
latest reset (this feature is not active by default),
English