Burkert Type BBS-4S - Manual (Page 5)

11
8. MAINTENANCE
WARNING!
Danger – high pressure and discharge of medium!
• Before loosening the nuts or screws, always turn off the pressure
and relieve the lines.
• Wear protective equipment if media is hazardous.
• Nuts or screws may be retightened on pressurized lines only by
technicians in consideration of special precautions.
• When shutting down the equipment, ensure that no unauthorized
voltage increases and pressure surges can occur.
• Following maintenance, ensure a controlled restart.
Have the product serviced regularly by technicians!
All types of silicone hoses should be checked for damage and embrit-
tlement after a deployment period of 6 months.
Inspection and maintenance work includes in particular monitoring and
ensuring the
• leak-tightness,
• identification,
• proper mode of operation of the safety and warning devices.
9. SPARE PARTS
CAUTION!
Risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable spare parts may cause injuries
and damage the product and the surrounding area.
• Use only original accessories and original spare parts from Bürkert.
Spare parts are: O-rings, hoses
The spare parts can be ordered from your Bürkert sales office.
NOTE!
Replace wearing parts in time
• The durability of the wearing parts is the responsibility of the plant
operator. Replacement of wearing parts in a timely manner must be
observed.
english
12
10. RECOMMENDED AUXILIARY
MATERIALS
10.1. Product Designations and
Manufacturers
In this manual the following auxiliary materials are recommended for
faultless operation, maintenance and repair of the device:
Type of aux-
iliary material
Product designation Manufacturer and Internet
address
Glycerin Glycerin anhydrous
with FDA certificate,
suitable for DI use as
excipient emprove
EXP PH EU
Merck KGaA
www.merckmillipore.com
Mounting
paste
Mounting paste Klüber
UH1 96-402
Klüber Lubrication
www.klueber.com
11. TRANSPORT, STORAGE,
DISPOSAL
NOTE!
Transport damage!
Inadequately protected products may be damaged during
transportation.
• Transport the product in a firmly assembled state, protected against
moisture and dirt, in shock-resistant packaging.
Incorrect storage may damage the product.
• Prevent the temperature from exceeding or dropping below the
permitted storage temperature.
• Store the product in a dry and dust-free location!
• Store O-rings and hoses dry and protected from UV radiation and
for not longer than 3 years.
• Do not wind up product in excess of its natural bending radius
(danger of bending).
• Storage temperature -40 to +80°C.
Damage to the environment caused by products contaminated
with media.
• Dispose of the product and packaging in an environmentally friendly
manner!
• Observe applicable disposal and environmental regulations.
english
Type BBS-04