Burkert Type 8623 - Manual (Page 11)

8623-2-Standard - 9
english
5 COMMISSIONING
NOTE Interference with the device is only allowed by specialist
personnel using suitable tools! Before interfering with the flow
controller, always switch off the voltage!
ATTENTION!
On screwing the flow controller onto the proportional valve,
make sure the seal is correctly seated!
5.1 Connecting to the proportional valve
➔ ➔ ➔ ➔ ➔ Unscrew the 4 screws on the front panel of the flow controller and remove
the cover carefully.
➔ ➔ ➔ ➔ ➔ Place the housing of the flow controller with the seal onto the valve.
➔ ➔ ➔ ➔ ➔ Screw the flow controller tightly to the valve.
➔ ➔ ➔ ➔ ➔ Place the cover on the flow controller and screw it tight with the 4 screws.
Fig.: Connecting the flow controller to the proportional valve
ATTENTION!
Make sure the cover is placed on the right way round
(pinned strips must engage in the sockets).