beautypg.com

Fluid installation, Safety instructions – Burkert Type 8696 User Manual

Page 13

background image

13

Fluidinstallation

Push the positioner, without turning it, onto the actuator until no
gap is visible on the form seal.

NOTE!

Too high torque when screwing in the fastening screw does
not ensure protection class IP65 / IP67!
• The fastening screws may be tightened to a maximum torque of

0.5 Nm only.

Attach the positioner to the actuator using the two side fastening
screws. In doing so, tighten the screws only hand-tight (max.
torque: 0.5 Nm).

Supports

Pilot air ports

(actuator)

Fastening

screws

max. 0.5 Nm

Fig. 6:

Installation of positioner, 2103 and 23xx series

8. FLUID INSTALLATION

8.1. Safety instructions

DANGER!

Risk of injury from high pressure!
• Before dismounting pneumatic lines and valves, turn off the

pressure and vent the lines.

Risk of electric shock!
• Before reaching into the device or the equipment, switch off the

power supply and secure to prevent reactivation!

• Observe applicable accident prevention and safety regulations

for electrical equipment!

WARNING!

Risk of injury from improper installation!
• Installation may be carried out by authorized technicians only

and with the appropriate tools!

Risk of injury from unintentional activation of the system and
an uncontrolled restart!
• Secure system from unintentional activation.
• Following installation, ensure a controlled restart.

english

Type 8696