Burkert Type 8793 - Manual (Page 37)

37
Auxiliaryfunctions
8. auXiliary functionS
8.1. overview of auxiliary functions
The following auxiliary functions can be added to the device menu:
CHARACT Selection of the transfer characteristic between input signal and stroke (correction
characteristic)
CUTOFF Sealing function for position controller
DIR.CMD Effective sense of direction between input signal and nominal position
DIR.ACTUATOR Assignment of the aeration state of the actuator chamber to the actual position
SPLITRANGE Signal split range; input signal as % for which the valve runs through the entire stroke
range.
X.LIMIT Limit the mechanical stroke range
X.TIME Limit the control speed
X.CONTROL Parameterize the positioner
P.CONTROL 10) Parameterize the process controller
SECURITY Code protection for settings
SAFE POSITION Definition of the safety position
SIGNAL ERROR Configuration of signal level fault detection
BINARY INPUT Activation of the binary input
OUTPUT Configuration of the output (option)
CAL.USER Calibration (only a device menu item can be activated)
SET FACTORY Reset to factory settings (only a device menu item can be activated, run RESET: see
chapter “7.1. Overview of basic functions”)
SERIAL IO Configuration of serial interface
EXTRAS Configuration of display
POS.SENSOR 11) Setting interface for remote sensor
SERVICE For internal use only
SIMULATION Simulation (only a device menu item can be activated)
DIAGNOSE Diagnostic menu (option)
Table 9: Auxiliary functions
10)
Only available for process controller Type 8693 and 8793
11)
Only available for process controller Type 8793 - only possible for Type 8793 Remote
English
Software Tool - 8x92 / 8x93