Burkert Type 8793 - Manual (Page 16)

16
Installation
5.2. installing pactware and dtms
Select the appropriate PACTware version depending on the operating system in use, see chapter “5.1. System
requirements”.
All installation programs are available on the Bürkert homepage and on CD.
Before the installation, exit all programs that are open.
5.2.1. pactware version 3.6 and .net framework 1.1 including
Sp1
Installation of PACTware requires the presence of software platform:
Microsoft .NET Framework 1.1 with Service Pack 1 (SP1)
procedure to follow if "Microsoft .NET Framework 1.1 with Service Pack 1 (SP1)" is not present yet on the target
computer:
→
Download and / or open the Zip file (1000103878), which includes the Microsoft.NET 1.1 framework.
→
Start "Dotnetfx.exe".
→
Download and / or open the Zip file (1000103880), which includes the Microsoft.NET 1.1 SP1 framework.
→
Start "NDP1.1sp1*.exe".
procedure pactware Setup:
→
Download and / or open the Zip file (1000103690), which includes the PACTware setup and unzip in a tem-
porary directory.
→
Start “Setup.exe”.
Setup file "PACTware36setup.zip" contains
• the basic setup for PACTware 3.6 with online help in various languages
• the HART communication DTM for PACTware 3.6
• the Generic HART DTM (not required)
After you have selected the installation language, the installation is performed.
At this point the HART communications DTM can also be installed. It is required because communication with
Bürkert devices runs via the HART protocol and the physical layer has an RS232 interface rather than a HART
interface.
English
Software Tool - 8x92 / 8x93