Burkert Type 8793 - Manual (Page 28)

28
Operationandfunction
procedure example: function X.TUNE:
→
Set up connection
→
Set up TUNE FUNCTIONS in the navigation area
→
Start X.TUNE. To do this, click Start X.TUNE
6) .
The progress of X.TUNE is shown in the communication software:
XTUNE start POS 100 ... XTUNE end
► ► ►
Automatic adjustment can be interrupted with the
Break X.TUNE
button.
When the automatic adjustment completes, the message "XTUNE end" appears 7) .
The changes are automatically transferred to the positioner's / process controller’s memory (EEPROM) after the
X.TUNE function is successful.
After X.TUNE is complete, read the device parameter for processing from the positioner / process con-
troller (see chapter “6.4.1. Reading parameters from the device”).
Figure 22: X.TUNE (example Type 8693)
6)
X.TUNE can also be started on the positioner / process controller (see the relevant device operating
instructions).
7)
If an error occurs, an error message appears (see Chapter “6.6. Error messages”).
English
Software Tool - 8x92 / 8x93