Burkert Type 6650 User Manual

Page 2

3. INTENDED USE

Incorrect use of the flipper solenoid valves type 6650
can be dangerous to people, nearby equipment and
the environment.
• The device is a media-separated solenoid valve and

has been designed for use in conjunction with gases

and fluids (see Bürkert Chemical Resistance Chart:

www.burkert.com).

• Do not use the device outdoors without appropriate

protective measures.

• Use according to the permitted data, operating condi-

tions and conditions of use specified in the contract

documents and operating instructions.

• The device is not intended for operation without suit-

able power reduction electronics and must be oper-

ated only within the framework of the intended duty

cycle.

• Transport, store, install, operate and maintain the

device correctly as described in the operating

instructions.

• Use the device only as intended.

3.1. Restrictions

If exporting the system/device, observe any existing
restrictions.

english

4. BASIC SAFETY

INSTRUCTIONS

These safety instructions do not make allowance for any
• contingencies and events which may arise during the

installation, operation and maintenance of the devices.

• local safety regulations; the operator is responsible for

observing these regulations, also with reference to the
installation personnel.

Danger – high pressure!
• Before loosening the lines and valves, turn off the

pressure and vent the lines.

Risk of burns/risk of fire if used continuously through
hot device surface!
• Keep the device away from highly flammable sub-

stances and media and do not touch with bare hands.

• Do not exceed the max. permitted duty cycle (see chap-

ter “6.1. Operating Conditions”)

• Do not obstruct the heat dissipation that is required for

the operation.

General hazardous situations.
• The flipper solenoid valve type 6650 is not to be used

in areas where there is a risk of explosion.

english

• The connection clamps between coil and fluid housing

must not be removed under any circumstances.

• Do not make any internal or external changes to the

device.

• Do not put any loads on the housing (e.g. by placing

objects on it or standing on it).

• Installation and repair work may be carried out by

authorised technicians only.

• Ensure that the system cannot be activated

unintentionally.

• After an interruption in the power supply or pneu-

matic supply, ensure that the process is restarted in a

defined or controlled manner.

• The device may be operated only when in perfect

condition and in consideration of the operating

instructions.

• The general rules of technology apply to application

planning and operation of the device.

english

NOTE!

Electrostatic sensitive components / modules!
The power reduction electronics, which is available as an
accessory, contains electronic components which react
sensitively to electrostatic discharge (ESD). Contact with
electrostatically charged persons or objects is hazardous
to these components. In the worst case scenario, they
will be destroyed immediately or will fail after start-up.
• Observe the requirements in accordance with EN

61340-5-1 and 5-2 to minimize or avoid the possibility
of damage caused by a sudden electrostatic discharge!

• Do not touch live electronic components!

english

Type 6650