Burkert Type 6013 - Manual (Page 7)

7
General information
4. GENERAL INFORMATION
4.1. Contact addresses
Germany
Bürkert Fluid Control Systems
Sales Center
Christian-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]
International
Contact addresses can be found on the final pages of the printed
operating instructions.
And also on the Internet at:
www.burkert.com
4.2. Warranty
The warranty is only valid if the device is used as intended in accordance
with the specified application conditions.
4.3. Information on the Internet
The operating instructions and data sheets for Type 6013 can be found
on the Internet at:
www.burkert.com
5. APPLICATION CONDITIONS OF
THE DEVICES
5.1. Use in the hazardous area
The device may be used either in the hazardous area of gas
or dust but not in a hybrid mixture.
5.2. Operation only with associated
valve
The solenoid coils may be operated only with a valve body with minimum
dimensions: 32 mm x 32 mm x 10 mm made of metal or plastic. A larger
valve body with better heat conductivity may be attached at any time.
5.3. Individual assembly, block
assembly
• Solenoid coils type AC10 - 5: are suitable for individual and block
assembly.
• Solenoid coils type AC10 - 6: are suitable only for individual assembly
NOTE!
For block assembly observe the following:
• Dimensions of the valve body: 32 mm x 32 mm x 10 mm.
• Material of the valve body: Brass (MS), plastic (PA 6 GV),
stainless steel.
english
PTB 01 ATEX 2101