beautypg.com

Burkert Type 3239 User Manual

Page 15

background image

15

Installation

8.2.3 installation position T-valve Type 3234

For the installation of the T-valves into circular pipelines, we recommend
the following installation positions:

When media is supplied:

When media is removed:

Fig. 7: Installation position type 3234

8.2.4 installation position y-valve Type 3239

For the installation of the Y-valves into systems, we recommend the
following installation positions:

When media is supplied:

When media is removed:

Fig. 8: Installation position type 3239

8.2.5 installation of the tank bottom valve

Type 3235

For further information on containers and welding instructions,
please refer to the standard ASME VIII Division I.

It is recommended to weld the valve prior to the container
installation. However, it is possible to weld the valves to ready-
assembled containers.

prior to welding, please check to ensure that:
• The tank bottom valve does not collide with other equipment compo-

nents and assembly/disassembly of the actuator is always possible.

• A minimal distance between two welding joints three times the

thickness of the container wall is adhered to.

It is recommended to weld the valve in the center of the drain
to ensure optimum draining of the container.

The diameter of the hole in the container and the flange must be equal.
The valve has two welding edges to make welding and positioning
of the valve easier. The length of the welding edges is approximately
3 mm. In case the thickness of the container wall exceeds 3 mm, the
valve must be positioned as shown in Fig. 9.

Prior to welding the valve, grind the outlet wall.

english

Type 3232, 3233, 3233 K, 3234,

3235, 3239

This manual is related to the following products: