Flowline LU29-1 EchoSonic II - Manual (Page 9)

23 MAR 11 EchoSonic II 9 of 24
Rev B MN300610
USB® Fob Interface
EchoSonic II communicates with WebCal through a USB® interface called a Fob. Before plugging your
Fob into your computer’s USB® port, be sure that you have installed WebCal on your computer.
Connect the red, green, white and black wires from EchoSonic II into the correct terminals on the Fob.
Tighten the screws on the terminals and plug your Fob into the USB® port of your computer.
* Once EchoSonic II is configured and prior to installation, isolate the white and green wires
from active power to prevent a short of the configuration circuit
WebCal
With EchoSonic II connected to your computer, open the WebCal software by clicking on the WebCal
icon. Follow steps 1-3 to configure the transmitter. Click “Help” in the lower right hand corner and open
the help menu of WebCal for additional instructions on WebCal. If you need additional assistance using
WebCal, please contact a Flowline Applications engineer at (562) 598-3015