Flowline LU29-1 EchoSonic II - Manual (Page 6)

6 of 24 EchoSonic II 31 MAR 11
MN300610 Rev B
Warning:
Always use the Viton gasket when installing the EchoSonic II, and make sure that all electrical wiring of the
switch is in accordance with applicable codes.
Components:
EchoSonic II is offered in three different models. Depending on the model purchased, you may or may not have
been shipped all the components shown below. You do however, need an EchoSonic II, USB® Fob and
Viton® gasket to configure, install and operate EchoSonic II.

EchoSonic II
o LU27-01 - 9.8’ (3 m) range, Type 6P encl., 1” NPT
o LU27-11 - 9.8’ (3 m) range, Type 6P encl., 1” G
o LU23-01 – 18.0’ (5.5 m) range,
Type 6P encl., 2” NPT
o LU23-11 – 18.0’ (5.5 m) range,
Type 6P encl., 2” G
o LU28-01 – 26.2’ (8 m) range,
Type 6P encl., 2” NPT
o LU28-11 – 26.2’ (8 m) range,
Type 6P encl., 2” G
o LU29-01 – 32.8’ (10 m) range,
Type 6P encl., 2” NPT
o LU29-11 – 32.8’ (10 m) range,
Type 6P encl., 2” G

Viton Gasket
o Part #200128 for LU27 series
o Part #220129 for LU23, LU27 or LU29 series

USB® Fob
o Part #LI99-1001

Quick Start Guide