EXP Computer HD Traveler E - Manual (Page 22)

- 20 -
12. To format the hard drive, open the My Computer icon, right-click on
the NEW removable drive, and re-enter the MS-DOS mode again. Start
the FDISK program, then verify your changes.
Change A Drive Letter Assigned to the Portable Hard Disk
To change a drive letter for the Portable Hard Disk
(for example, from drive “D” to drive “E”), follow
the instructions below.
1. Open the “Control Panel”, then “System”.
Select the “Device Manager” tab, double click
“Disk Drives”, select the model of the Portable
Hard Disk, then click the “Properties” button.
2. Select the “Settings” tab, check the
“Removable” under options, and then change
the “Start drive letter” and the “End drive letter”
to the letter you wish to choose. The drive letter
will be changed after restarting your computer.
FCC COMPLIANCE STATEMENTS
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the Distance between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.