EXP Computer HD Traveler E - Manual (Page 15)

- 13 -
SOFTWARE INSTALLATION FOR WINDOWS NT
Before You Begin
♦
Be sure that Windows NT is version 3.51 or higher.
♦
Since Windows NT does not support the “Hot Insert/Remove” feature,
the PCMCIA Portable Hard Disk should be connected with your
computer prior to starting Windows NT. Likewise, do not remove the
PCMCIA Portable Hard Disk before you shut down Windows NT.
♦
In Windows NT, the I/O and IRQ settings of the PCMCIA Portable
Hard Disk can not be changed. Therefore, if the setting conflicts with
other devices that you are using, change the I/O or IRQ of other device
to avoid conflicts.
Install the PCMCIA Portable Hard Disk under Windows NT
To install the PCMCIA Portable Hard Disk device driver, double click the
“SCSI Adapter” icon from “ Control Panel” folder. (In Windows NT 4.0,
you may select “Control Panel”, under “Settings” from the “Start” menu
to open the “Control Panel” folder.)
Click the “Drivers” tab, and a figure illustrated as below will be displayed.
Click the “Add” button, and then click the “ Have Disk...” button.
Windows NT will then prompt you to insert the manufacturer installation
disk. Insert the PCMCIA Portable Hard Disk device driver diskette into
your floppy drive. Specify the directory as A:\WINNT (or B:\WINNT
whichever contains the diskette) and select OK. When the following