A&D Super Wash Down Scales SW-150KL - Manual (Page 20)

18
10.2. Entering the comparator values
1. In the weighing mode, press and hold the SAMPLE switch to enter the comparator
value setting mode.
2. Enter the comparator values using the following switches.
UNITS To shift the blinking digit to the right.
PRINT To increase the value of the blinking digit by one.
SAMPLE To switch the polarity.
Each time the switch is pressed, “-“ is turned on and off at the left-
most digit. When on, the value is negative.
TARE To confirm and store the setting value.
3. When the setting is complete, “
end ” is displayed and the scale returns to the
weighing mode.
Five-level comparator mode Three-level comparator mode
Weighing mode
Press
and hold
To set the LOLO
limit value
To set the LO
limit value
To set the HI
limit value
To set the HIHI
limit value
Weighing mode
Press
Press
Press
Press
Press
Press
Weighing mode
To set the LO
limit value
To set the HI
limit value
Weighing mode
Press
and hold