A&D Super Wash Down Scales SW-150KL - Manual (Page 11)

9
6.2. Switches
The switches are touch-sensitive. Three levels of switch sensitivity are available and
can be set in the function setting “
key
“. When set to “
key 2
“ (High), the switches
can be operated with a gloved finger.
Switch Description
ON/OFF switch
Turns the power ON or OFF.
When turned ON, the scale will be automatically set to zero (power-on zero).
To turn the power OFF, press and hold the switch.
Note: If pressing the switch does not turn the power ON immediately, keep
pressing the switch.
SAMPLE switch
In the counting mode (“pcs”), goes to the unit weight storing mode.
Press and hold to go to the comparator value setting mode.
PRINT switch
Outputs the weight value to the printer.
In the setting mode, this switch is used to increase the value of the selected
blinking digit by one.
UNITS switch
Switches the weighing unit.
In the setting mode, this switch is used to shift the blinking digit to the right.
ZERO switch
Zeroes the scale and sets the display to zero. (See below.)
TARE switch
Subtracts the tare (container) weight placed on the weighing pan. (See below.)
In the setting mode, this switch is used to store the setting value and proceed
to the next step.
‰ The ZERO switch will zero the scale if the weight value is within ±2% of the
weighing capacity (kg) around the power-on zero point. The ZERO indicator
turns on. (ZERO operation)
‰ The TARE switch will tare the scale and subtract the weight to zero as a tare
weight when the weight is a plus stable value. In this case the ZERO and NET
indicators turn on. (TARE operation)
When the tare is removed while the tare operation is in progress and the scale
returns to the zero point, the ZERO
and NET indicators turn on. In this case
the displayed tare value will be negative.
(Note: In some countries or areas, the ZERO indicator will not turn on
during the TARE operation.)
‰ When the tare is removed while the TARE operation is in progress and the ZERO
operation described above is performed, the tare operation previously done is
cleared and the NET indicator turns off.
(Note: In some countries or areas, after the ZERO operation, the TARE
operation will not be cleared without pressing the TARE switch.)