EXP Computer CD Traveler Series CD-620, CD-820, CD-1020, and CD-2020 with Portable CD-ROM card - Manual (Page 18)

- - 16
Using the PCMCIA CD-ROM to Install Windows NT 4.0
Boot up the computer using either a Windows NT boot disk, which should have our
CD-ROM drivers on them or DOS bootable diskette with CD-ROM driver.
Start with WinNT32 /b or WinNT /b (if you boot from DOS). This will install
Windows NT without copying to floppy disks.
There will be a point where the installation program will ask you for a Mass Storage
device.
You have to skip that and do not providing any drivers.
Once installation is complete then load our drivers from SCSI Adapter icon.
If you are installing from Windows 95 then the best way to do it from there is to use
the DOS mode. at the DOS prompt WinNT32 /b
or boot disk and skip the process of
creating the NT disks.