Asus Barebone System Vintage-PE2 - Manual (Page 43)

A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 2 - 2 7 2 - 2 7 2 - 2 7 2 - 2 7 2 - 2 7
4. Connect the floppy disk drive
signal cable to the signal
connector at the back of the
drive.
5. Connect a power cable from
the power supply unit to the
power connector at the back of
the floppy disk drive.
4
5
F L O P P Y 1 F L O P P Y 1 F L O P P Y 1 F L O P P Y 1 F L O P P Y 1
c o n n e c t o r c o n n e c t o r c o n n e c t o r c o n n e c t o r c o n n e c t o r
6. Connect the other end of the
signal cable to the floppy disk
drive connector (FLOPPY1) on
the motherboard.