beautypg.com

Asus Barebone System Vintage-PE2 User Manual

Page 41

background image

A S U S V i n t a g e - P E 2

A S U S V i n t a g e - P E 2

A S U S V i n t a g e - P E 2

A S U S V i n t a g e - P E 2

A S U S V i n t a g e - P E 2

2 - 2 5

2 - 2 5

2 - 2 5

2 - 2 5

2 - 2 5

To install an IDE hard disk drive:

1.

Follow steps 1-5 of the
previous section.

2.

Connect the blue interface of
the IDE ribbon cable to the
primary IDE connector (blue
connector labeled PRI_IDE1)
on the motherboard.

S e r i a l A T A

S e r i a l A T A

S e r i a l A T A

S e r i a l A T A

S e r i a l A T A

c o n n e c t o r s

c o n n e c t o r s

c o n n e c t o r s

c o n n e c t o r s

c o n n e c t o r s

8.

Connect the other end of the
Serial ATA cable to a Serial
ATA connector on the
motherboard.

4

3

3.

Connect the gray interface of
the IDE ribbon cable to the IDE
connector on the drive.

4.

Connect a 4-pin power plug from
the power supply unit to the
power connector at the back of
the drive.

P R I _ I D E 1

P R I _ I D E 1

P R I _ I D E 1

P R I _ I D E 1

P R I _ I D E 1

c o n n e c t o r

c o n n e c t o r

c o n n e c t o r

c o n n e c t o r

c o n n e c t o r

This manual is related to the following products: