Asus Barebone System Vintage-PE2 - Manual (Page 35)

A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 2 - 1 9 2 - 1 9 2 - 1 9 2 - 1 9 2 - 1 9
To install an expansion card:
1. Lay the chassis on a stable
surface.
2. Remove the metal cover
opposite the slot that you wish
to use.
3. Align the card golden fingers
to the slot and its metal
bracket to the slot opening on
the chassis.
4. Press the card firmly until it is
properly seated on the slot.
5. Secure the card to the chassis
with a bracket screw.
P C I E x p r e s s P C I E x p r e s s P C I E x p r e s s P C I E x p r e s s P C I E x p r e s s
x 1 6 s l o t
x 1 6 s l o t x 1 6 s l o t x 1 6 s l o t x 1 6 s l o t
M e t a l c o v e r M e t a l c o v e r M e t a l c o v e r M e t a l c o v e r M e t a l c o v e r
A G P s l o t A G P s l o t A G P s l o t A G P s l o t A G P s l o t
2.6.2 2.6.2 2.6.2 2.6.2 2.6.2 Expansion card installation Expansion card installation Expansion card installation Expansion card installation Expansion card installation
2.6.3 2.6.3 2.6.3 2.6.3 2.6.3 Configuring an expansion card Configuring an expansion card Configuring an expansion card Configuring an expansion card Configuring an expansion card
After installing the expansion card, configure it by adjusting the software
settings.
1. Turn on the system and change the necessary BIOS settings, if any.
See Chapter 5 for information on BIOS setup.
2. Assign an IRQ to the card. Refer to the tables below.
3. Install the software drivers for the expansion card.
P C I s l o t s P C I s l o t s P C I s l o t s P C I s l o t s P C I s l o t s