Asus Barebone System Vintage-PE2 - Manual (Page 40)

2 - 2 4 2 - 2 4 2 - 2 4 2 - 2 4 2 - 2 4 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
If your Serial ATA HDD has both 4-pin and 15-pin connectors at the
back, use either the 15-pin SATA power adapter plug O R
O R O R O R O R the legacy
4-pin power connector. D O N O T D O N O T D O N O T D O N O T D O N O T use both to prevent damage to
components and to keep the system from becoming unstable.
7. Connect a 15-pin Serial ATA power plug from the power supply unit to
the power connector at the back of the drive.
- O R - - O R - - O R - - O R - - O R -
Connect a 4-pin (female) power plug from the power supply unit to
the 4-pin (male) power connector at the back of the drive.
4. Push the drive into the bay
until its screw holes align with
the holes on the bay.
4 4
H D D s c r e w h o l e s H D D s c r e w h o l e s H D D s c r e w h o l e s H D D s c r e w h o l e s H D D s c r e w h o l e s
5. Secure the drive with two
screws on each side of the
bay.
6. Connect one end of the Serial
ATA cable to the SATA
connector at the back of the
drive.
6
7
5 5