Delta Controls DPT-2000 User Manual
Page 24
22 IOM-DPT-A: FEB 2014
MID_WP_________
(Lock modify the parameters associated with MID)
|
\
|
BACK
(Back to the Local Menu. If you approve this option,
|
|
return back to the main menu Tree Local)
|
|
|
|
(Submit one of the following through constant
|
|
◙ pressing. Once approved, the parameter transmitter
|
|
will confirm receipt of the command message "DONE")
|
|
|
|
|
ON
(Lock Activation parameters affecting the metrology)
|
|
|
OFF
(Turns lock parameters affecting the metrology)
Local Menu, error reports..
During executing in Local Menu some functions, LCD2 announcement can be displayed on the screen.
The error displaying evidences about no realization of command of Local Menu.
The shortened description of errors announcements is showed below
.
ERR_L07
[in_write_protected_mode]. Error will ensue out when we try to change setting in Local
Menu, but transmitter is protected before recording. To to make the change of setting with
Local Menu using, transmitter has to have the included service of Local Menu as well as
switched off protection before record. These parameters modification is possible by using
KAP -03 communicator, DPT2000 program or software using library EDDL.
default setting:
Local Menu service
switched on
protection before record
switched off
ERR_L09
[applied_process_too_low]. Error will ensue out when given parameter (temperature)
will too low. Zeroing or the range setting verifying is necessary.
ERR_L10
[applied_process_too_low]. Error will ensue out when given parameter (temperature)
will too low. Zeroing or the range setting verifying is necessary.
ERR_L14
[span_too_small]. Error will ensue out when in result of setting range executing change
the width of the range will be smaller than admissible.
ERR_L16
[acces_restricted]. Error will ensue out when the service of Local Menu is switched off,
and the user tries to call out the Menu Local service. You should switch on the service of
Local Menu with the KAP-03 communicator, DPT2000 program, or software using library
EDDL.