Delta Controls DPT-2000 - Manual (Page 2)

Symbols used
BASIC REQUIREMENTS AND SAFE USE
- The manufacturer will not be liable for damage resulting from incorrect installation,
failure to maintain the device in a suitable technical condition, or use of the device
other than for its intended purpose.
- Installation should be carried out by qualified staff having the required authorizations to
install electrical and pressure-measuring devices. The installer is responsible for
performing the installation in accordance with these instructions and with the
electromagnetic compatibility and safety regulations and standards applicable to the type
of installation.
- The device should be configured appropriately for the purpose for which it is to be used.
Incorrect configuration may cause erroneous functioning, leading to damage to the device
or an accident.
- In systems with pressure transmitters there exists, in case of leakage, a danger to staff on
the side where the medium is under pressure. All safety and protection requirements
must be observed during installation, operation and inspections.
- If a device is not functioning correctly, disconnect it and send it for repair to the
manufacturer or to a firm authorized by the manufacturer.
In order to minimize the risk of malfunction and associated risks to staff, the device is not
to be installed or used in particularly unfavourable conditions, where the following
dangers occur:
- possibility of mechanical impacts, excessive shocks and vibration;
- excessive temperature fluctuation,
- condensation of water vapour, large dust, icing.
Installation of intrinsic safety versions should be performed with particular care, in
accordance with the regulations and standards applicable to that type of installation.
Changes to the products manufacturing documentation may forestall a paper user updating.
Current Instruction Manual is available at Producer http on
www.delta-controls.com .
Symbol Description
Warning to proceed strictly in accordance with the information contained in the
documentation in order to ensure the safety and full functionality of the device.
i
Information particularly useful during installation and operation of the device.
Information particularly useful during installation and operation of a type Ex device.
Information on disposal of used equipment