2 tread – CEMB USA ER100 (A) User Manual
Page 42
42
Use and Maintenance Manual Rev. 11-2010
ENGLISH
Goes to the peak/peak and first harmonic graph
screen.
Goes to the tread analysis screen
Prints the information screen
Return to main screen
6.14.2 Tread
Tread analysis can be performed
During the balancing cycle to obtain an average value measured over the whole tyre width.
1.
No extra time is required.
Enable a special measuring cycle using the button
2.
to obtain the tread value for the three different areas:
inside edge, centre and outside edge of the tyre.
The cycle time is slightly longer.
By law (to be verified for each country) the minimum tread thickness must be 1.6mm at each point.
It is quite normal for tyres to wear irregularly and that the pivot pins wear more on one side.
By means of tread analysis at several points, you can measure the tyre tread depth with adequate accuracy on the
edges and in the centre.
Use of the wheel balancing machine
- K22 Installation Manual (12 pages)
- K22 User Manual (20 pages)
- C206 User Manual (16 pages)
- C212 User Manual (20 pages)
- C218 User Manual (24 pages)
- C202 (25 pages)
- C29 User Manual (16 pages)
- K10 User Manual (16 pages)
- K8 (18 pages)
- K9 (20 pages)
- K11 User Manual (20 pages)
- C71_2 evo (F) User Manual (24 pages)
- C71_2 SE evo (B) (22 pages)
- C71_2 evo (D) User Manual (24 pages)
- C73-L (B) (28 pages)
- ER60 User Manual (22 pages)
- ER80 User Manual (24 pages)
- ER85 User Manual (28 pages)
- ER100 (80 pages)
- DWA 1000XLT (65 pages)
- SM900 (50 pages)
- SM56T (70 pages)
- SM935 (58 pages)
- SM915 (48 pages)
- SM915 Maxi (50 pages)
- SM825 (50 pages)
- C65 (E) (25 pages)
- C65 (F) (25 pages)
- C65 (G) (24 pages)
- C61 (D) (20 pages)
- C218 (A) (23 pages)
- C212 (A) (15 pages)
- C211 (C) (20 pages)
- C206 (A) (20 pages)
- ER100-i (B) (86 pages)
- ER80 (A) (24 pages)
- ER80 (B) (24 pages)
- ER80 (C) (24 pages)
- ER80 (D) (24 pages)
- C88 (A) (39 pages)
- C88 (B) (39 pages)
- C88 EVO (C) (32 pages)
- C68SE (B) (32 pages)
- K9 (A) (20 pages)