CEMB USA C218 (A) - Manual (Page 9)

I 0568 - 9
5
GB
5.3 - Presetting of wheel dimensions
5.3.1 - Automatic presetting (see also CORRECTION MODE )
5.3.1.1 - Standard wheels
The screen appears upon removing the distance + diameter gauge.
The “dimension acquired” message is indicated by the correction weight symbol, which changes from blue to red.
Using the special grip, move the end of the gauge against the rim in one of the positions A/B indicated in fi gure 5.
Note: Always use the round part of the striker plate.
- Hold the gauge in position for at least 2 seconds.
If the acoustic signal is enabled (see
ACOUSTIC SIGNAL ), the acquisition of the dimensions is accompanied by a
“beep”.
The calibration performed as such is necessary for modes AL1,2,3,4,CTS,Static, Dynamic.
Manually presetting is possible by using the push buttons as described in
MANUAL PRESETTING .
N.B. Depending on the preset diameter, the machine is automatically set to truck mode (diameter ³18”
or 450 mm) or car mode. However such selection can be changed at any moment in the
Measurement screen (see section RESULT OF MEASUREMENT ).