CEMB USA C218 (A) - Manual (Page 10)

I 0568 - 10
b b
6 6a
GB
Set the distance+diameter gauge to the rest position.
The current width value is displayed inside the tyre.
- Set the nominal width, which is normally shown on the rim, or measure the width “b” with
the caliper gauge provided.
The other enabled buttons are:
select the type of weight to apply (see CORRECTION METHODS )
car/truck selection
select the dimensions presetting in manual mode screen.
return to initial frame.
launch balancing.
5.3.1.2 - Wheels ALUS
After the measurement performed for the FI inner side, as indicated in fi g. 6, pull out the gauge again to store the
data for the FE outer side (fi g. 6a); choose position A or B (fi g. 5) at your choice. Keep this position for at least 2
seconds. The counterweight symbols change colour.
When the acoustic signal is enabled (see
ACOUSTIC SIGNAL ), the acquisition is accompanied by a “beep”.
ALUS inside I ALUS outside E
Position of adhesive weights