CEMB USA ER85 (A) - Manual (Page 12)

12
FI
FE FI
Pos B
Pos A
Use and maintenance manual Rev. 09-2013
ENGLISH
a) Standard weight
Using the special grip, move the end of the gauge against
the rim in one of the positions A/B shown.
b) Adhesive weight: in the position indicated below.
INdIcATIoN
always use the round part of the striker plate
Hold the gauge in position for at least 2 seconds.
If the acoustic signal is enabled (
ACOUSTIC SIGNAL ),
the acquisition of the dimensions is accompanied by a “beep”.
Set the distance+diameter gauge to the rest position.
The other enabled buttons are:
This button is used to improve the dimensional
calibration of large-diameter wheels such as off-
road, trucks, wheels which protrude significantly
from the rim. Press this button several times to
select the type of tyre projection (from 1.0” to
2.0”). The option is disengaged at the end of current
Width Measurement.
selecting the manual dimension presetting screen
5.2.1.1 Automatic width measurement
Slowly lower the guard after making the automatic measu-
rement of the distance + diameter to automatically measure
the wheel width.
If the width measured is incorrect (out of range), the following
message appears:
“Sonar measure is out of range:”
= repeat”
= manual set-up”
Press to re-lower the guard and repeat the width
measurement. Press to go to the dimensions panel
for manual insertion of the width measurement. Manually
presetting is possible by using the push buttons as described
in
“ PRESETTING OF WHEEL DIMENSIONS”.
5.2.2 ALUS wheel automatic presetting (adhe-
sive weights)
Make two consecutive measurements inside the rim on
two correction planes of your choice as indicated in figu-
re. When the acoustic signal is enabled (
ACOUSTIC
SIGNAL ), the acquisition is accompanied by a “beep”.
The enabled buttons are:
user call/save control
selecting the manual dimension presetting
screen
return to initial screen.
Close the guard to perform a balancing spin.
Position of adhesive weights
Use of the wheel balancer
select the type of weight to
apply ( CORRECTION
METHODS ).
return to initial frame
Close the guard to perform a balancing spin.
Position of adhesive weights