beautypg.com

C.E. Niehoff & Co. N1307/N1307-1 Alternators Installation User Manual

N1307 alternator w/ remote-mounted regulator

background image

II0100A

Page 1 of 1

N1307-1 Alternator w/ N3109 Regulator

—or—

N1307 Alternator

w/ Remote-Mounted Regulator

Installation Instructions

This symbol is used to indicate
presence of hazards that can cause
minor property damage.

CAUTION

Install alternator as shown in Figure 1:

Slip bushing located in rear mounting
foot must be securely tightened against
alternator mounting bracket on engine.
Failure to do so can result in broken
mounting feet or broken upper mounting
bracket.

Figure 1 - N1307/N1307-1 Alternator Installation Details

CAUTION

1. Units are shipped with shaft collar, washer, and

locknut. Remove shaft collar. Install pulley speci-
fied by customer, washer, and locknut. Torque
locknut to 163 Nm/ 120 lb. ft.

2. Use hardened washers between aluminum surfaces

and bolt heads and nuts. Torque mounting bolts as
shown in Figure 1.

3. All cabling, wiring or conduit must be supported

within 305 mm/12 in. of termination on alternator.

C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-643-4633

B+ terminal (see inset above)

T

T

T

T

T

B– terminal (either side)

5/16-18 UNC 2A Bolt –

torque to 9 Nm/82 lb. in.

T

T

T

T

T

12mm/0.50 Locknut –

torque to

95 Nm/70 lb. ft.

T T T T T

Hardened washer

T T T T T

Slip bushing must be tightened against
bracket — see “CAUTION” above

T T T T T

12mm/0.50 in.

mounting bolt

(full length)

TTTTT

Hardened

washer

TTTTT

Alternator mounting

bracket on engine

T

T

T

T

T

Vehicle harness

connection

T T T T T

Bracket

on engine

3/4-16 UNF 3B Locknut
and hardened washer—
torque to 163 Nm/120 lb.ft.

T T T T T

T T T T T

3/8” Mounting bolt,

grade 5 or higher

Hardened washers

T T T T T

TTTTT

T

T

T

T

T

3/8” Locknut –

torque to 38 Nm/29 lb. ft.

Customer B+ output

cable terminal

T T T T T

T T T T T

T T T T T TTTTT

Lock washer

Washer

1/2-13 UNC 2A Bolt –

torque to 32 Nm/23.5 lb. ft.

T

T

T

T

T

Alternator B+ terminal

4. Choose wire gauge for B+ and B– cables capable of

handling maximum alternator output with minimum
voltage drop.

5. N1307-1: N3109 regulator was shipped as factory-

installed on original alternator. If alternator was
replaced, re-install regulator on alternator and
torque mounting hardware to 3.4 Nm/30 lb. in.

N1307 with remote-mounted regulator: Install
regulator as specified by customer.