C.E. Niehoff & Co. C703 Alternator w/Diode Module Installation - Manual (Page 2)

II0054B
Page 2 of 2
C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-643-4633
FIGURE 5
6. Install C703 alternator and new mounting
bracket. See Figure 4. Make sure there is
enough clearance between mounting bracket
and drive end housing to prevent damage to
wires. See Figure 5.
7. Attach cable from 12V Transformer-Rectifier
box on vehicle to middle terminal on module.
See Figure 6. Tighten screw on module to
5.1 Nm/45 lb. in. Coat module terminal with
Dow Corning®1-2577 Low VOC RTV coating
or equivalent. Do not use coating containing
acetic acid (vinegar smell) on electrical
components.
8. Slip cable into wire clamp and attach clamp
with bolt and lock washer to anti-drive end
housing as shown in Figure 6. Tighten
hardware to 5.1 Nm/45 lb. in.
9. Install drive end cover plate on alternator and
secure front cover bolts to 2.8 Nm/25 lb. in.
FIGURE 4
FIGURE 6