Kaiser KCT 69.. User Manual
Page 38
38
EN
Countdown timer
If the control is OFF the standalone-timer can be
operated by activating the timer key
1.
The timer display shows «00».
Operation of the Power-key
2 puts the control
back into the stand-by mode and the stand-
alone-timer will be cut-off.
Adjustment range (0-99min), it can be set in 1-
minute steps with any key (
+) 3, starting at 1
up to 99 (end stop) with the minus-key (
–) 4
starting at 99 down to 0 (end stop).
Continuous activation of the (
+) or (–) key
results in a dynamic increase of the
adjustment speed up to maximum value
without sound signal.
When the (
+) or (–) key is released in the meantime,
the adjustment speed starts again from a (low) initial
value.
Adjustment can be made with a continously activated
(
+) or (–) key or by tip-operation (with sound signal)
After the timer is set the time runs down according to
the adjustment.
When the time is over there is a sound signal and the
timer display blinks.
The sound signal will be stopped automatically after 2
minutes and/ or by operating any key.
Then the blinking of the timer display stops and the
display extinguishes.
2
4
1
3