Kaiser KCT 69.. - Manual (Page 22)

22
EN
USAGE
COOKING ZONES CONTROL
MODELS KCT 69...
Switching ON/ OFF
After mains voltage is applied the control initialises
for approx. 1 second before it is ready for operation.
After a reset all displays and LEDs glow for approx. 1
second.
When this time is over all displays and LEDs
extinguish and the control is in the Stand-by mode.
By operating the ON/ OFF key
1 the control can be
turned into the ON-mode.
The cooking zone displays show a static
0.
If a cooking zone is in the «hot» status, the display
shows a static
H instead of 0.
The bottom right dot
2 is blinking in 1 second
intervals on all cooking zone displays to indicate that
no cooking zone is selected at the moment.
After switching-ON the electronic control remains
activated for 20 seconds.
If no cooking zone or timer selection follows within
this period of time, the electronic control
automatically switches back into the stand-by-mode.
Should it recognize key activation other than that, the
control remains in the stand- by-mode.
If the child safety feature is active when switching on,
all cooking zones show
L, (LOCKED). (also refer to
Key lock).
If the cooking zones are in a «hot» status, the display
shows
L and H in alternation.
The control can only be switched-ON if it identifies
the ON/ OFF key alone being operated.
When the Touch Control is ON it can be switched-
OFF at any time by operating the ON/ OFF key. This
is also valid if the control has been locked (activated
child safety feature).
The ON /OFF key has always priority in the switch-
OFF function.
When the control is ON it automatically switches-
OFF after 20 seconds if no cooking zone or select
key has been operated within this period of time.
If case of a cooking zone selection, the automatic
switch- OFF time is composed of 10 seconds
deselection time for a cooking zone at setting
0 and
10 seconds switch-OFF time.
1
2