PA Industries MINI Servo Roll Feed SRF-105M through SRF-320 - Manual (Page 19)

Form 1145 Mini Installation Form and Operation Manual 02/02/2006
19
5.6 SPEED PERFORMANCE GRAPH
The speed performance graph shown below is to be used as a guide only. Actual feeder/press speeds may vary
depending on factors such as material thickness, width, rigidity, surface finish, and free loop.
Feed Angle (degrees):
0
100
200
300
400
500
600
700
0 1 2 4 6 8 10 14 18 22 26 30 40 50 60
Feed Length, Inches
Strokes Per Minute
270 180 90
Figure 6.