MoTeC SDL - Manual (Page 5)

MoTeC Overview 3
Numeric Displays
The three numeric displays (Left, Right and Top Right) can be programmed to
display any value.
Note that each of the three numeric displays has a different number of digits
and are therefore suited to displaying different values. For example the Top
Right display can only show values up to a maximum of 199 and is therefore
not suitable for displaying Lap Times, but is suitable for displaying many other
values such as Lap Number, Fuel Remaining, Engine Temperature etc.
The numeric displays can show any channel value plus an override value,
shown each time the value is updated. This is useful for values that are
updated periodically, for example Lap Time. The override values are shown
for a programmable period of time, for example a numeric display could
normally show the Running Lap Time (which is continuously updating) then
be overwritten by the Lap Time for 10 seconds each time the Lap Time is
updated.
Enunciators for some of the common display values are provided above the
numeric displays, eg. ET (Engine Temperature), OP (Oil Pressure).
Centre Numeric Display