MoTeC SDL - Manual (Page 16)

14 Overview
• Note that if the SDL is connected to a MoTeC M800 ECU the M800
sensors should be calibrated in metric otherwise special scaling will be
required.
Lap Beacon
A Lap Beacon can be connected to the SDL in order to record Lap Times for
display and to provide lap reference information for the data logging analysis
software.
The MoTeC Lap Beacon consists of a Transmitter which is mounted beside
the track and a Receiver which is mounted in the vehicle.
A switch can also be used to generate lap times, although this is significantly
less accurate than a lap beacon system.
For further details refer to the Lap Beacon manual.
Options
Various options allow the SDL to be upgraded to perform additional functions,
specifically wide band lambda measurement and Pro Analysis.
The options can be enabled at any time by calling your MoTeC dealer,
purchasing the upgrade and then entering the upgrade password.
See Appendix B: Options Summary for details.
Software
The SDL comes with software packages for managing the SDL and analysing
the logged data. All software required is available on the CD provided, or can
be downloaded from the internet. Go to
www.motec.com.au and follow the
links to “Software”.
The software must be run on a laptop or desktop computer running Windows
98/2000/XP.
The following software programs are provided: