DE-STA-CO S/SM300A - Manual (Page 28)

26
SECTION 8: Repair and Replace (continued)
FOLLOWER NO. FM-50; FM-62; FM-75
FIGURE 10
DISASSEMBLY:
Remove jam nut, setscrew, follower and nylon plug.
ASSEMBLY:
Clean the follower stud hole in the hub and inspect for an out-of-round condition, which could cause
backlash by failing to support the stud at the top.
Apply a light coat of assembly grease to a new cam follower and install it firmly against seat; loosen
and retighten. Install new nylon plug and tighten setscrew and jam nut in place.