DE-STA-CO S/SM300A - Manual (Page 16)

14
SECTION 5: Adjustments (continued)
5.1.2. S/SM162 - S/SM300A
Industrial Motion Control’s S/SM162 - S/SM300A has an adjustable internal clutch. The torque setting is
adjusted by tightening 3 or 4 (depending upon unit size) independent screws (clockwise rotation
increases the torque setting). The screws should be run all the way in, then adjusted equivalent
amounts (in 1/4-turn increments) from that point. The adjusting screws are retained and sealed by a
vibration resistant thread coating. This coating could, over a number of adjustments, wear out.
Reapplication of this coating will return screws to manufacturers specifications.
FIGURE 6