DE-STA-CO S/SM300A - Manual (Page 25)

23
SECTION 7: Troubleshooting (continued)
TROUBLESHOOTING GUIDE
Symptom Cause Solution
OIL LEAKS AT:
Seals Worn or damaged seal Replace seal; polish shaft
and/or shaft surface
Shims Damaged shim Replace; apply “Loctite Aviation
Grade Sealant” to both sides
Cap Screws Shim damaged between screw Replace gasket or shim; apply
hole and interior of housing “Loctite Aviation Grade
Sealant” to both sides
Holes drilled through Remove screw, apply
“Loctite Threadlocker” and
re-install
Cover joints Inadequate sealant Remove, clean and
reassemble with silicone
rubber sealant
Oil service pipe fittings Not properly sealed Remove, clean and reinstall
with “Loctite Teflon Pipe
Sealant”
NOTE: In the event that damage is found, it is recommended that the unit be returned to the
factory for repair or that an Industrial Motion Control Serviceman make or supervise repairs in
your plant. Proper alignment and adjustment of the components are essential to their
performance and life.