DE-STA-CO S/SM300A - Manual (Page 15)

13
SECTION 5: Adjustments
The FD & Sentry Drives are solid mechanical, backlash-free mechanisms. There are no adjustments
required on the Indexer during installation unless it is furnished with a torque limiting device or a motor
drive package equipped with speed control. After the Indexer has been installed and set up with the
user’s load in place, it will be necessary to check these items for proper adjustment and settings.
NOTE: The drive should be in the center of dwell and dowel pinned to the base before installing
accessories, as previously mentioned in 4.1.1. & 4.1.5.4.
5.1. Internal Torque Limiters (‘S’ Series only)
5.1.1. S/SM100
FIGURE 5
Industrial Motion Control’s S/SM100 is the same as the previously offered FD100 with the internal clutch.
That means that this unit has a non-adjustable internal clutch. Also, this unit, unlike the other Sentry
units, has a junction box on the unit to mount the proximity switch.