Atec Fluke-724 - Manual (Page 22)

724
Users Manual
12
Table 4. Key Functions (cont.)
No Name Description
L L
Cycles through :
E Slow repeating 0 % - 100 % - 0 % ramp
P Fast repeating 0 % - 100 % - 0 % ramp
N Repeating 0 % - 100 % - 0 % ramp in 25 % steps
AM
AM OY
OZ
Disables Shut Down Mode
Enables Shut Down Mode
M XW
Y Z
Increases or decreases the source level.
Cycles through the 2-, 3-, and 4-wire selections.
Moves through the eight memory locations of calibrator setups.
In Contrast Adjustment mode; up-darkens contrast, down-lightens contrast.
N Q
Retrieves a previous calibrator setup from one of eight memory locations.
O S
Saves the calibrator setup to one of eight memory locations. Saves Contrast Adjutment setup.
P M
Cycles the calibrator through MEASURE and SOURCE modes in the lower display.
Q T Selects TC (thermocouple) measurement and sourcing function in the lower display. Repeated pushes cycle through
the thermocouple types.
R V
Toggles between voltage, sourcing, and measuring functions in the lower display.
S R Selects RTD (resistance temperature detector) measurement and sourcing function in lower display. Repeated
pushes cycle through the RTD types.
T U
Selects the ohms measurement and sourcing function.