Atec Kikusui-PLZ1003W - Manual (Page 6)

Copyright © 2001 KIKUSUI ELECTRONICS CORP. All rights reserved. http://www.kikusui.co.jp/ Page6
PLZ-3W/3WH series
ELECTRONIC LOAD (CC·CR·CV·CP)
● Actual-load simulations
The sequence function is used to capture real waveform data into the
memory card. This allows actual-load simulations to be conducted.
Capturing Data:
The load current of a motor is captured using an oscilloscope, and
the waveform data is saved in the memory card of the PLZ-3W/
3WH through the GPIB interface.
Calling the data:
As the data stored in the memory card is available even when the
GPIB interface is disconnected, you can do actual-load simulations
in test lines or without integrating a complicated system.
Applications
● Automatic test system for DC current
Combining the PLZ-3W/3WH Series with a Kikusui PCR-L Series
AC power supply allows you to configure an automatic test system
for switching power supplies.
AC input side test ... PCR-L Series:
● Power line abnormality simulations
● AC line regulation tests
● Instantaneous power failure tests and others
DC roading test ... PLZ-3W/3WH Series:
● Loading simulations
● Load regulation tests
● Transitional response tests
● Current-limiting characteristic tests and others
GPIB
Contoroller
PCR-L Series for setting
input conditions
AC power
Switching power
supply
PLZ-3W/3WH Series for
setting loading conditions
Digital oscilloscope Data acquisition
by the COR5500U Series or other models
I
I
GPIB
DC power supply
Motor or other equipment
Storing waveform
Controller Data transfer
COR5500U Series digital oscilloscope
or other models
Transferring to
memory card
PLZ-3W/3WH
Series
Memory card
Disconnecting the GPIB interface
Memory card
DC power supply
PLZ-3W/3WH Series